If you continue to have trouble with a sensor after following the troubleshooting above, feel free to reach out to our help desk by emailing or by phone at (877)668-4660. If the Resync Door Task feature does not help - or resyncing is not available for the task that you are trying to test - you may need to recalibrate your sensor by deleting and re-adding the task.If your sensor says that your door is open when the door is closed then use the Resync Door Task feature to recalibrate your sensor. If you do not get a notification from the door task, check to see that your sensor is reporting the correct status for your door.The app might take a moment before you get a notification. Its a 20/year cost to factor into the devices cost. and Ive had to replace the battery twice. Your Flume 1 water Sensor uses 4 AA Lithium-Metal Batteries you can order your own screwdriver and batteries using the attached (paid) links. Monitor Your Water Use to Reduce Waste & Save Money. For example if your sensor is for a door, try opening the door. Find helpful customer reviews and review ratings for Flume 2 Smart Home Water Monitor & Water Leak Detector: Detect Water Leaks Before They Cause Damage. Test an event to see if your sensor sends a notification.Once your sensor is awake and connected to your bridge, let's make sure it's reporting events correctly , 1981 ), a multistage timer for sampling interval. (Note: You may need to give the mobile app a minute to update after your sensor reconnects.) water quality samples under such conditions requires that the sampler can. Here you can view a list of your sensors and their connection status.You can also check the Notion app to confirm that your sensor is back online. Inspect the inside of the case for any moisture. Remove the lid from the case and remove all 4 batteries. Once it flashes green, you can move your bridge back to its original location. How do I change the battery in my flume To replace your batteries, please follow these steps: Take a picture of the black water sensor device on your meter. If your bridge is connected to your WiFi but your sensor does not flash green, you may need to temporarily move your bridge closer to the sensor until it reconnects. Next let's make sure your sensor is connected Twist the sensor body back on to the gray baseplate, all the way until you feel a click.Wait until you see the LED flash green, that indicates it has reconnected to your bridge. Reinstall the batteries in the sensor – the LED light should briefly flash red when the batteries are back in the sensor.Remove the batteries from the sensor and leave them out for 10 full seconds.Twist the sensor body counterclockwise and remove it from the gray baseplate.How to cycle the batteries in your Notion Sensor: If you don't see the LED flash, then try cycling the batteries. When you install new batteries, the sensor's LED should briefly flash. ![]() Occasionally a sensor needs a little extra help after replacing a battery.įirst, make sure the batteries are new and non-rechargeable, and they are oriented correctly in the battery compartment. Notion recommends standard Alkaline AAA batteries for Gen 3 Notion Sensors, and Energizer Ultimate Lithium AAA batteries for Gen 2 Notion Sensors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |